跳至主要内容

BTMA--What do I do if the crusher is hard to start?

 



We all know that the extensive crusher can overload over time, causing the machine to fail. However, it is important to take precautions. There are many reasons.

1. To avoid excessive friction in cold weather, make sure to lubricate the crusher as often as possible.

2. This problem is caused by repeated starting and frequent use of the comprehensive crusher.

3. The wear on the bearing glands of the comprehensive crusher causes the dust collector to become damaged. This results in some dust being mixed into the hydraulic system and a reduction in the machine's lubricity.

This is why we also have a solution:

1. To avoid production accidents, special personnel should be designated for comprehensive crusher maintenance.

2. You should ensure that the feed's body size is uniform and avoid excessive occurrence.

3. Select the right lubricant to adjust the machine. After the machine is turned off, it should be left to idle for a while to let out any wood chips or dust. This will help to reduce impurities.

Follow the comprehensive crusher start-up procedure. Make sure that you clean the machine daily according to the original design.

标签：

评论

发表评论

此博客中的热门博文

BTMA--Can the crusher handle wet materials

The crusher converts the fruit tree pruning waste branches into biomass fuel. This allows for recycling and protection of the environment. Many people ask if this equipment can handle wet materials. The crusher's performance is affected by the moisture content. Different crushers have different requirements regarding the moisture content. A higher moisture content can hinder the process of materials. Below 6% moisture level will have a good effect on the processing. This has a huge impact on crusher work and can also have a significant impact on equipment output and performance. Normal circumstances will result in the wood being fibrous when it is wet and hit with the hammer. If there are fibers, this will impact the performance of the hammer when processing. This crusher is effective. This will result in a lower efficiency. The output of the work will therefore be lower. The fiber in the middle of dry wood will be less than that of dry wood. Therefore, if the hammer or the blad...
发表评论
阅读全文

BTMA--Choosing a counterattack crusher manufacturer

The impact crusher is a machine that crushes the material by squeezing the material between the rotor and the hammer. It has a large feed inlet and conveys materials through a high-speed rotating rotor. When the plate hammer rotates, it will hit the materials in the crushing cavity and throw them upward into the impact plate. As a result, the material is crushed and then thrown out of the crushing chamber. The final particle size can be adjusted by adjusting the distance between the rotor and the impact frame. To determine which impact crusher is best for a given application, consider the following: material to be crushed, electric drive, pre-screening before the crusher, overload system, pan feeder under the crusher, and service And operator friendly. Finally, choose an impact crusher with the correct size and specifications. When purchasing an impact crusher, please consider the flow of materials through the machine. It is very important to choose the right size impact crusher manu...
3 条评论
阅读全文

BTMA PEX jaw crusher

The PEX jaw crusher series has the characteristics of high crushing ratio, uniform size of crushed products, reliable operation and low cost. It is widely used in stone mining and metallurgical industries. Its unique design also enables it to crush materials with compressive strength less than 320MPa. It is easy to use and maintain. Its structure is simple, and it is also easy to move and install. The machine is designed to meet various crushing needs in various industries such as construction, mining, quarrying and recycling. BTMA PEX jaw crusher is characterized by its powerful processing capacity, from one to nine tons per hour. It can crush different kinds of minerals, including rocks, ore and coal. The processing capacity of one to nine tons per hour is a good choice for processing various ores and rocks. The total cost of the machine includes moving jaws, side guards, and electricity costs. The discharge port is located in the lower part of the crusher body. The movable jaw is ...
2 条评论
阅读全文